Legging patterns low wrise how to#

The best way to do this is to put on your muslin at your natural waist, and gradually move it lower down you body until the crotch is at a comfortable spot for you. If so, you’ll first want to determine how much to lengthen it by. If you’re taller than 5′ 6″, or have a longer torso than the Calder is drafted for, you may want to lengthen the rise.

Legging patterns low wrise how to#

How to Lengthen the Rise of the Calder Pants Pin your back waistband elastic with safety pins rather than topstitching so that you can reuse the elastic on your final pair of Calders. For a quick-and-dirty version of the Calder, sew up View C (the shorts) and leave out the pockets. When you make an adjustment like this, it’s always a good idea to make a second muslin to check the new fit. If you’re making View A (mid-calf) or View B (full length), remember to attach the lower leg piece to the back pelvis piece before cutting into your fabric. Now we can fold the bottom line up to meet the top line, and smooth out the crotch curve and side seam.Īnd there is our adjusted back pelvis piece. I prefer to do this adjustment before I’ve attached the bottom portion of the leg, to make the pattern piece easier to manage. We’re going to do the same thing here: draw two parallel lines to the top lengthen/shorten lines, 1/2″ (12 mm) away from those lines. Our front piece is now done, and we can move onto the back piece! Using a French curve, smooth out both edges of your pattern piece. You’ll notice that the crotch curve and side seam need smoothing out now. We’ve now removed 1″ (2.5 cm) of length from the rise. We want to focus on the top one, since this is the one that impacts the rise (the rest allow you to adjust the length of the legs).Ĭontinuing with our example above, we’re going to draw two lines parallel to the lengthen/shorten lines, 1/2″ (12 mm) up and down from those lines.įold the bottom line you drew up to meet the top line you drew, and tape in place. You’ll notice that there are multiple lengthen/shorten lines on this piece. For example, if your fold is 1/2″ (12 mm) on both sides, the amount you’ll reduce the rise by is 1″ (2.5 cm). Measure the two sides of the fold and that will give you the amount by which you need to shorten the rise. Carefully test this new length by sitting down-you’ll want to make sure that there is enough room between your body and the crotch of the pants to be comfortable while seated. Adjust this fold until the crotch is sitting where you want it to be, and then pin it all around. The best way to do this is to put on your muslin, and then make a horizontal fold around the middle of your pelvis, all the way around your body. If you find that you need to shorten the rise of the Calders, you’ll want to first determine by how much.

How to Shorten the Rise of the Calder Pants For more details on how the Calder should fit, check out this guide. If the crotch is lower on your body than you’d like, you can shorten the rise, and likewise if the crotch is digging into your body, you can lengthen the rise. The best way to determine whether you need to adjust the rise is to make a muslin (use View C, the shorts version, if you want use less fabric) and try it on. Depending on your proportions, you may find that your torso is shorter or taller than the Calder is designed for. The Calder Pants & Shorts are high-waisted trousers, designed to sit at the natural waist and drafted for a height of 5′ 6″.

Today, we’ll show you how to adjust the rise of the Calders. The Calder Pants & Shorts are wide-leg trousers with a chic flat front and comfortable elastic back waistband.